RotFix Usage Information

RotFix® Epoxy
Wood Restoration System

RotFix® penetrates deep into deteriorated and rotted wood, creating a strong, solid base for restoration. After application, a patch may be built up with SculpWood®, which can be finished in a normal manner. Use for the repair of rotted and deteriorated, dried out, or spongy wood. Excellent for both interior and exterior use. RotFix® penetrates deep into the wood, hardening into a strong, water resistant mass.

DIRECTIONS:

Mix two parts of RotFix® Epoxy (part A) with one part of RotFix® Hardener (part B) by volume. Mix
no more that can be applied within 30 minutes. For easy measurement, use the special mixing applicator squeeze bottle (one included in kit, extras available).

APPLICATION:

Apply to affected area with mixing / applicator squeeze bottle, syringe, brush or roller. The wood must be very dry (15% moisture content or less). Repeat as necessary until wood is solodified.

SYSTEM THREE

Epoxies & Adhesives

TECHNIQUE:

In extreme cases of deep rot, drill a series of holes into the decayed matter and pour liberally into the affected area. Allow ample time for RotFix® to soak well into the area. Repeat if necessary.

CLEANUP:
UNCURED MIXED RotFix® (part A and part B) may be cleaned up with white vinegar then flushed with water.
SAFETY:
ALWAYS WEAR PROTECTIVE DISPOSABLE GLOVES WHEN USING THIS PRODUCT. Avoid skin contact. Skin sensitization may result from prolonged and repeated contact. If use causes soreness, redness, blistering, or other symptoms of irritation, stop use and see a physician immediately. Use with adequate ventilation. If eye contact occurs, flush with large quantities of water and contact a physician immediately. Do not use around open flame. If part A is swallowed, induce vomiting. If part B is swallowed, DO NOT induce vomiting.
Keep out of reach of children.

WARRANTY: No representations or warranties
of fitness to specific application are made. As application is out of our control, product is sold without guarantee. System Three Resins, Inc’s and/or the vendors sole liability shall be limited to refund of purchase price

See SculpWood
Moldable Epoxy Putty reverse side:

System Three, SculpWood, and Rotfix are
registered trademarks of Systrem Three Inc. 12/10/99

Wood Finish Supply

Tech. & Info: Tech Sheets SysThree:Epoxies & Adhesives Home: www.woodfinishsupply.com

This page - - http://www.woodfinishsupply.com/SculpWood.html

TECHNIQUE:

In extreme cases of deep rot, drill a series of holes into the decayed matter and pour liberally into the affected area. Allow ample time for RotFix® to soak well into the area. Repeat if necessary.

CLEANUP:
UNCURED MIXED RotFix® (part A and part B) may be cleaned up with white vinegar then flushed with water.

SAFETY:
ALWAYS WEAR PROTECTIVE DISPOSABLE GLOVES WHEN USING THIS PRODUCT. Avoid skin contact. Skin sensitization may result from prolonged and repeated contact. If use causes soreness, redness, blistering, or other symptoms of irritation, stop use and see a physician immediately. Use with adequate ventilation. If eye contact occurs, flush with large quantities of water and contact a physician immediately. Do not use around open flame. If part A is swallowed, induce vomiting. If part B is swallowed, DO NOT induce vomiting.
Keep out of reach of children.

WARRANTY: No representations or warranties
of fitness to specific application are made. As application is out of our control, product is sold without guarantee. System Three Resins, Inc’s and/or the vendors sole liability shall be limited to refund of purchase price